How to make your own skateboard bedding

How to Make Your Own Skateboard Bedding This DIY DIY tutorial will show you how to make a DIY skateboard design, headband and bedding.

You will need:1 1/4 inch x 4 inches vinyl sheeting, cut to size1 1.5 inch x 5 inches polyfill (such as a plastic sheet)1 1 foot x 4 feet rope (such a long piece of string)1 large sheet of foam (such like cotton or cotton swab)1 3/4 inches x 5 feet rubber sheet1 1 gallon of water3/4 cup of vinegar1/2 teaspoon baking soda1/4 teaspoon salt1.

First, cut your vinyl sheet to size.

Lay the piece of vinyl on the floor and fold over the edges to form a rectangle.

2.

Place your rope around the edge of the vinyl.

3.

Place the polyfill over the rope.

4.

Place all the pieces of polyfill in a large bowl and mix with the vinegar and baking soda.5.

Pour the vinegar over the polyfilled mixture and mix thoroughly.6.

Pour in the water and mix until the mixture is just combined.7.

Mix in the baking soda, salt, vinegar and mix again.8.

Place a large sheet on top of the polyfoam, lay the plastic sheet over it and then fold the poly foam over the plastic.9.

Cut the rope and hang the bedding on the end of your rope.